STUDY NOTES     QUESTIONS WITHOUT ANSWERS   

 
1. In the block diagram shown, the "linear amplifier" is:
   1. an amplifier to remove distortion in signals from the transceiver
   2. an optional amplifier to be switched in when higher power is required
   3. an amplifier with all components arranged in-line
   4. a push-pull amplifier to cancel second harmonic distortion
   ========= Answer is b =========

    

2. In the block diagram shown, the additional signal path above the "linear amplifier" block indicates that:
   1. some power is passed around the linear amplifier for stability
   2. "feed-forward" correction is being used to increase linearity
   3. the linear amplifier input and output terminals may be short-circuited
   4. the linear amplifier may be optionally switched out of circuit to reduce output power
   ========= Answer is d =========

    

3. In the block diagram shown, the "low pass filter" must be rated to:
   1. carry the full power output from the station
   2. filter out higher-frequency modulation components for maximum intelligibility
   3. filter out high-amplitude sideband components
   4. emphasise low-speed Morse code output
   ========= Answer is a =========

    

4. In the block diagram shown, the "SWR bridge" is a:
   1. switched wave rectifier for monitoring power output
   2. static wave reducer to minimize static electricity from the antenna
   3. device to monitor the standing-wave-ratio on the antenna feedline
   4. short wave rectifier to protect against lightning strikes
   ========= Answer is c =========

    

5. In the block diagram shown, the "antenna switch":
   1. switches the transmitter output to the dummy load for tune-up purposes
   2. switches the antenna from transmit to receive
   3. switches the frequency of the antenna for operation on different bands
   4. switches surplus output power from the antenna to the dummy load to avoid distortion.
   ========= Answer is a =========

    

6. In the block diagram shown, the "antenna tuner":
   1. adjusts the resonant frequency of the antenna to minimize harmonic radiation
   2. adjusts the resonant frequency of the antenna to maximise power output
   3. changes the standing-wave-ratio on the transmission line to the antenna
   4. adjusts the impedance of the antenna system seen at the transceiver output
   ========= Answer is d =========

    

7. In the block diagram shown, the "dummy load" is:
   1. used to allow adjustment of the transmitter without causing interference to others
   2. a load used to absorb surplus power which is rejected by the antenna system
   3. used to absorb high-voltage impulses caused by lightning strikes to the antenna
   4. an additional load used to compensate for a badly-tuned antenna system
   ========= Answer is a =========

    

8. In the block diagram shown, the connection between the SWR bridge and the antenna switch is normally a:
   1. twisted pair cable
   2. coaxial cable
   3. quarter-wave matching section
   4. short length of balanced ladder-line
   ========= Answer is b =========

    

9. In this block diagram, the block designated "antenna tuner" is not normally necessary when:
   1. the antenna input impedance is 50 ohms
   2. a half wave antenna is used, fed at one end
   3. the antenna is very long compared to a wavelength
   4. the antenna is very short compared to a wavelength
   ========= Answer is a =========

    

10. In the block diagram shown, the connection between the "antenna tuner" and the "antenna" could be made with:
    1. three-wire mains power cable
    2. heavy hook-up wire
    3. 50 ohm coaxial cable
    4. an iron-cored transformer
    ========= Answer is c =========